How to install the actuator?

1.Prepare to connect the two wires of the actuator to a 12 volt battery

2.Red wire to the positive terminal and Black wire to negative terminal will make the actuator extend. To make it retract, just reverse the terminal connections.

3.To simplify the last step, you can prepare a reverse polarity relay or switch (not included) for the actuator. When you want the actuator to extend and retract, just press the switch.

4.Your actuator will hold its position when the power is off. It will automatically stop when reaches the end.

5.The actuator has pre-installed inner limit switch, it cannot be adjustable.