Launch CRE Diagnostic Tool fit for Chrysler Supports Full Special Resets - DON'T BUY ANY SOFTWARE AT MALL
CONTINUOUSLY GROWING WITH UPDATES, which usually only be available from car Dealer Level Scanners or much more Expensive Professional Tools
Q : WHY CAN'T SEE ANY RESETS on my scanner, as its advertised 31 free service functions.
A :The "RESET" option on home screen is a place to store software purchased at mall, which is prepared for other brands. Don't need to buy any resets fit for Chrysler brands, all free resets are in the related systems. For example, to connect 2014 Chrysler Challenger, the way to use TCM‘s special functions should be to go to Diagnose>Automatically Search>System Selection> Transmission Control Module (TCM) > Special Functions, then you will be able to see the list of special functions supported by this system, There are more than 31 types of special functions for all systems combined.
PS: Functions vary by car models and years, please check the compatibility first.
- EPB Reset (Electronic Parking Brake Reset) : After replacing the brake pads, you need to reset the position of the brake pads before installing the new brake pads to close the warning light.
- Oil Lamp Reset : Close the oil service light, reset service mileage & service interval after replacing the engine oil, and the next maintenance calculation cycle is entered.
- SAS Reset (Steering Angle Calibration Reset) : Learn to correct the angle and solve the problem of the steering angle of the steering wheel.
- BMS Reset (Battery Register / Battery Maintenance) : Use the power management system, the battery needs to be re-matched after the battery is replaced, so that the car computer can recognize the new battery.
- ABS Brake Bleeding : When changing a new brake fluid, there is a high possibility that air will enter the brake fluid pipeline. In the traditional way, one person steps on the brake and another person changes the operating fluid. This function can perform the brake operation, and only one person is required to change the brake fluid.
- SUS Reset (Suspension) : This function needs to be performed to level the body height sensor in the air suspension system when the body height sensor and the control module or the car is leveled incorrectly.
- TPMS Reset (Tire Pressure Monitor System Reset) : When replacing TPMS sensors or the signal from the sensor is lost it can quickly look up the tire sensor from the vehicle’s ECU, reset tire pressure and turn off the tire pressure MIL.
- GEAR Reset (Gear Learning) : The vehicle has a crankshaft position sensor. This sensor collects the 58-tooth signal of the flywheel to determine the top dead center ignition time of a cylinder (reference signal). If this sensor is replaced, the reference will be lost, and gear signal learning is necessary.
- Injector Reset (Injector Coding) : The engine injector has a code. After replacement, you need to write a new code into the computer so that the car computer can correctly identify the injector.
- AFS Reset (Adaptive Frontlighting System) : It can detects the ambient light and then decides whether to turn on the headlights automatically. It can also adjust the headlights in time by monitoring the speed of the vehicle and the posture of the body.
11.Intelligent Cruise Control, 12.Engine Power Balance Moonitoring, 13.Motor Angle Calibration, 14. Head Light Fitting, 15.Seat Matching/Calibration, 16.Door and Window Initialization Study/Calibration, 17.Sunroof Initialization, 18.Air Suspension Matching, 19.Gearbox Matching, 20.Injector Calibration, 21.Multimedia Video Reset, 22.Cluster Reset, 23.Tire Change Reset, 24.Key Programming, 25.Coolant Bleed, 26.NOx Sensor Reset, 27.Stop/Start Reset, 28.Transport Mode, 29.Adblue Reset, 30.A/F, 31.A/C Relearn, more and more function will be kept growing and optimized constantly.